Touchwood is a tongue and groove panel made from real timber veneer pressed onto a 9mm moisture resistant MDF board. It gives the look of solid VJ timber panelling at a fraction of the cost and installation time. Available in Tasmanian Oak or Blackwood veneer on either a natural or black MDF backing.

Touchwood is incredibly versatile. It can be installed on walls, ceilings, bedheads, cupboard fronts, kitchen islands and joinery doors. It works equally well fixed vertically or horizontally and suits both modern and traditional interiors.

Very. Touchwood panels use a simple tongue and groove joining system and can be fixed directly onto plasterboard using construction adhesive and brad nails. Each panel is 1200mm wide and available in lengths up to 3600mm, so you can cover large areas quickly.

You can use clean straight cuts or finish with Touchwood's solid timber moulding profiles, available in Tasmanian Oak and Blackwood (20mm x 10mm x 3600mm) for neat wall-to-wall, wall-to-ceiling and wall-to-floor transitions. Simply nail the profiles into place with brad nails, fill any small gaps with timber putty and seal to match your panels. For full details, download the Touchwood Installation Guide.

Yes, Touchwood can be used in bathrooms and wet areas provided the space is well ventilated. The panels are made on a moisture resistant MDF substrate and when properly sealed with a wax, oil or polyurethane finish, they perform well in rooms with occasional humidity. Touchwood is not suitable for saunas, steam rooms or any enclosed space with prolonged high heat and moisture.

Yes, Touchwood can be used in bathrooms and wet areas provided the space is well ventilated. The panels are made on a moisture resistant MDF substrate and when properly sealed with a wax, oil or polyurethane finish, they perform well in rooms with occasional humidity. Touchwood is not suitable for saunas, steam rooms or any enclosed space with prolonged high heat and moisture.

Yes. Touchwood panels cannot be left raw and must be finished with a wax, oil or polyurethane in a finish of your choice. You can apply your chosen finish before or after installation.

Touchwood is made from PEFC certified timber veneer on PEFC certified moisture resistant MDF. The timber is sustainably grown, harvested and processed to meet the highest standards in quality and environmental practice. Because veneer panels use less solid timber than traditional lining boards, it is also a more resource efficient way to achieve the same look.